Stainless steel 304 mirror finish square bathroom shower hinge

Square bathroom clamp

Finish: mirror and satin

Material: stainless steel 304/316

Maintenance guidelines:

1. Our hinges are greased at the factory for quiet and trouble-free operation

2. If there is any squeaking that occurs after installation, put a drop of 3-in-1 oil (also known as household oil) on the white nylon washer that the hinge body pivots on

3. Washer is the component that acts as a buffer, so the body of the hinge doesn’t pivot directly on the brass center block

4. This solution doesn’t require the disassembly of the hinge

5. Note: do not use spray lubricant on these hinges, if the hinge has been disassembled, upon re-assembly, use white Lithium grease to lubricate the interior mechanism, never use an abrasive cleaner on the hardware, many of the components are coated with a clear lacquer drying the hardware with a clean, soft towel on a daily basis is the best way to maintain the hardware, if mineral deposits build-up, mix a couple of drops of a mild liquid soap (such as lvory or a similar product) into a cup of warm water, using a soft, non-abrasive cloth, clean the hardware, rinse thoroughly with clean, warm water and dry

Recommendations:

1. For public safety, we recommend the use of only tempered safety glass

2. Do not use power tools when installing these hinges

Use of gaskets:

1. For 3/8" (10mm) glass: use on thick gasket on each side

2. For 1/2" (12mm) glass: use on thin gasket on each side